Mon-Fri, 7am-5pm CST


Material Information

Nylon is one of the most widely used plastics because of its extreme strength, wear resistance, and self lubricating properties. Nylons are also known to be resilient and non marring, have high impact resistance has a continuous operating temperature of about 180º F, and a relatively light weight that makes it ideal for use in mechanical and electrical hardware to ease maintenance and replacement procedures. Nylon is commonly used as a replacement for bronze, brass, aluminum, steel and other metals to reduce weight and noise from metal to metal contact. Nylon 6/6 has the tendency to absorb moisture but is the least permeable to gasoline/mineral oil/fluorocarbon-refrigerant, the strongest, and most widely used, of all nylons. Its high crystallinity results in a sharp melting point, making its mechanical properties less affected by temperature. It can be found in the form of rod, tubing, or plate. 30% glass filled nylon type 6/6 is a glass reinforced extruded nylon 6/6. The glass reinforcement gives the material higher compressive strength and rigidity, as well as improved frictional characteristics.


  • Washers and stampings
  • Timing sprockets
  • Speedometer gears
  • Cooling fans
  • Wire connectors
  • Windshield wiper parts
  • Door-latch hardware
  • Molded fender extensions
  • Brake fluid resevoirs
  • Bearings
  • Business machines
  • Appliances
  • Industrial equipment


  • Light weight
  • Ability to operate without lubrication
  • High tensile strength
  • High elasticity
  • High heat distortion temperature
  • Resist wear, abrasion, and vibration
  • Can withstand sustained contact with a wide range of chemicals, alkalies, dilute acids, or oxidizing agents
  • Absorbs moisture
  • Low permeability to gasoline, mineral oil, and fluorocarbon-refrigerant


PhysicalAstm Test
Nylon Type 6/6
(30% Glass Filled)
Density (lb/in^3)D7920.049
Specific GravityD7921.35
Water Absorption @ 24 hours (%)D5700.7
Water Saturation (%)D5705.4
Tensile Strength (PSI)D63827,000
Tensile Modulus (PSI)D6381,400,000
Tensile Elongation at Break (%)D6383
Flexural Strength (PSI)D79039,000
Flexural Modulus (PSI)D7901,200,000
Compressive Strength (PSI)D695
Compressive Modulus (PSI)D695
Izod Impact (Notched), ft-lb/inD2562.1
Rockwell HardnessD785M101
Coefficient of Thermal Expansion,
Heat Deflection Temperature 264 psi, ºFD648482
Melting Point, °FD3418491
Continous Service Temp (Operating), °F230
Thermal Conductivity, BTU-in/hr-ft² °FC1771.7
Flammability RatingUL94HB
Dielectric Strength, Short Term,
(Volts/Mil) @ .125″ Thick
Volume Resistivity (ohm-cm) @ 73 ºF, 50%
Dielectric Constant at 60HzD1503.5
Dissipation Factor at 60 HzD1500.02

Disclosure: The information contained herein are typical values intended for reference and comparison purposes only. They should NOT be used as a basis for design specifications or quality control. Contact us for manufacturers’ complete material property datasheets. All values at 73°F (23°C) unless otherwise noted.


Product Quote Request

Scroll to Top