Material Information

Rulon® is the brand name for Saint Gobain’s reinforced PTFE. Filled PTFE offers a combination of high compressive strength, a low coefficient of friction, chemical resistance, electrical insulation, and excellent abrasion and corrosion resistance without the need for lubrication. These materials can run from -400º F to 500º F with or without lubrication, which makes them ideal for use in bearings or seals. Rulon® material specifically is known to have the unique property of no “slip stick”, which means it has no erratic motion at low speeds.

Rulon® AR has fillers that are ceramic in nature. This grade offers the best combination of flexibility (more flexible than Rulon® LR) and load carrying properties. It also has high wear resistance, low friction, good electrically insulative properties, and universal chemical inertness. It is commonly used for seals, piston cups, and some bearings. It is available in a maroon color in the forms of strip, rod, and tube.


  • Bearings
  • Washers
  • Seals
  • Piston cups


  • Universal chemical inertness
  • Best flexibility of Rulon® grades
  • Good load carrying properties
  • High wear resistance
  • Low friction
  • Good electrical insulator
  • No slip-stick


Astm Test Method

Rulon® AR

Rulon® LR

Rulon® J

Density (lb/in^3) D792 0.081 0.082 0.07
Specific Gravity D792 2.24 2.27 1.95
Water Absorption @ 24 hours (%) D570 0 0 0
Hardness, Shore D D2240 60-75 60-75 60


Tensile Strength (PSI) D1457 2,000 1,500 2,000
Tensile Elongation at Yield (%) D1457 175 150 180
Izod Impact (Notched), ft-lb/in D256 6 6


Coefficient of Thermal
Expansion, 10^-5/°F
D696 Varies with temp Varies with temp Varies with temp
Continous Service Temp (Operating), °F  – 500 500 500
Flammability Rating UL94 None None None


Dielectric Strength, Short Term,
(Volts/Mil) @ .125″ Thick
D149 400-500 400-500 200
Volume Resistivity (ohm-cm) @ 50% RH D257 1.0 x 10^15 1.0 x 10^15 8.0 x 10^18
Dielectric Constant at 1 MHz D150 2.5 2.5 2.4
Dissipation Factor at 1 kHz D150 0.003 0.003 0.001


The information contained herein are typical values intended for reference and comparison purposes only. They should NOT be used as a basis for design specifications or quality control. Contact us for manufacturers' complete material property datasheets. All values at 73°F (23°C) unless otherwise noted.