MC®907 (NYLON TYPE 6 – CAST UNFILLED)

MC®907 (NYLON TYPE 6 – CAST UNFILLED)

Material Information

Nylon 6 belongs to the cast nylon family of materials. Cast nylons offer the widest array of sizes or custom shapes of any thermoplastic. Nylons are a frequently used material as replacements for bronze, brass, aluminum, steel, and other metals, especially in bearing or wear applications. Nylons offer excellent wear and impact resistance, have high tensile strength and high modulus of elasticity, and have a high heat distortion temperature. They also resist wear, abrasion, and vibration. Nylons can also withstand a variety of chemicals, alkalis, oxidizing agents, and dilute acids. However, nylons do absorb moisture, so they are not recommended for wet applications. Because of its high crystalinity, Nylon 6 has better heat deflection, better solvent resistance, better hygroscopic characteristics, and better dimensional stability than Nylon 6/6. Nylon 6 is available in rod, tube, and sheet.

MC®907 is an unmodified cast type 6 nylon. MC®907 along with MC®901 have the highest strength and hardness of the nylon 6 grades. The natural colored MC®907 is FDA, USDA, and 3A-Dairy compliant.

Application

  • Food contact parts

Properties

  • Highest strength and hardness of nylons
  • FDA, USDA, and 3A-Dairy compliant (natural)
  • Lightweight
  • Absorbs moisture
  • High wear and impact resistance
  • High modulus of elasticity
  • High heat distortion temperature
  • Resists wear, abrasion, and vibration
  • High chemical resistance

Physical

Astm Test Method

MC®907 and
MC®901 Nylon

Density (lb/in^3) D792 0.042
Specific Gravity D792 1.15
Water Absorption @ 24 hours (%) D570 0.3
Water Saturation (%) D570 7

Mechanical

Tensile Strength (PSI) D638 12,000
Tensile Modulus (PSI) D638 400,000
Tensile Elongation at Break (%) D638 20
Flexural Strength (PSI) D790 16,000
Flexural Modulus (PSI) D790 500,000
Compressive Strength (PSI) D695 15,000
Compressive Modulus (PSI) D695 400,000
Izod Impact (Notched), ft-lb/in D256 0.4
Rockwell Hardness D785 R115

Thermal

Coefficient of Thermal Expansion,
10^-5/°F
D696 3.5
Heat Deflection Temperature 264 psi, ºF D648 200
Melting Point, °F D3418 420
Continous Service Temp (Operating), °F - 200
Thermal Conductivity, BTU-in/hr-ft² °F C177 -
Flammability Rating UL94 HB

Electrical

Dielectric Strength, Short Term,
(Volts/Mil) @ .125″ Thick
D149 500
Volume Resistivity (ohm-cm) @ 73 ºF, 50%
RH
D257 >10^13
Dielectric Constant at 60Hz D150 3.7
Dissipation Factor at 60 Hz D150 -

NOTE:

The information contained herein are typical values intended for reference and comparison purposes only. They should NOT be used as a basis for design specifications or quality control. Contact us for manufacturers' complete material property datasheets. All values at 73°F (23°C) unless otherwise noted.